Polymer-silicate premium paint is intended for use for indoor applications as a protective and decorative coating.

Terrix® IP-ST-P offers unique properties not available to other paints on the market. Based on innovative Swiss technology combining a silicate and dispersive binding agents. Due to its vapour permeable characteristic, it allows walls to naturally receive and give off moisture. In "wet rooms" (such as kitchens, bathrooms, laundry rooms, basements) the excess of moisture in the air may be easily reduced.

The composition of the paint is mineral which means the paint is free of surface electrostatics, in other words, it won’t attract any dirt or dust, and therefore its appearance won’t change over time.

Benefits to the customer

Click below to expand:

No flaking or cracking

Terrix® IP-ST-P paints bond to the substrate by chemical reaction. Traditional paints create a film on top of a substrate which can lead to peeling or cracking.

Very high resistance to wet scrubbing and washing

The product exceeds Category I (BS-EN-13300) requirements and it is suitable for use in heavy traffic areas.

Very high resistance to dirt

Not achievable by organic based paints on the market (all emulsions including acrylic, latex and silicon) it is due to its mineral formulation therefore lack of surface electrostatics. The dust wont’t be attracted to the paint.

Flame retardancy

Due to the lack of organic components in the paint and pigments used for colouring. In contrast to most paints on the market and all standard emulsion paints, Terrix® IP-ST-P provides protection against the spread of flame. Mineral characteristic of the paint makes it fully incombustible.

Very high resistance to yellowing

Built in UV blockers to maintain original look of paint.

Black mould and algae resistance

Increased Ph level (high alkalinity) delivers natural and long lasting protection. Terrix® IP-ST-P paints do not contain any Biocide (which are not recommended for internal use).

Suitability for swimming pools and high moisture environments

Due to its high permeable characteristics and chemical bonding to the substrate.

No mist coat or priming required

Sprayable directly onto plaster due to its chemical bonding properties. Two coats of paint only required.

Deep, quality matt appearance

Smooth, velvety finish that does not reflect light and provides a luxury appearance. The deep matt finish can also mask any wall imperfections.

Natural regulation of moisture levels

Due to microporous structure enabling the "free" travel of moisture and use of hydroscopic proprieties of the wall. Lower moisture levels means less expensive heating and lower risk of development of any asthmatic health conditions.

Benefits to the applicator

Spray application
Up to 10 times faster than traditional application.
No cracks, flaking or paint lifting
Even on substrateswith high levels of moisture content, due to chemical bonding and full vapour permeability.
Easy spot repairs, effortless snagging
The product consistency and formulationallows for simple snagging without need to repaint entire wall.
Can be applied on not fully dry substrates
Due to thepolymer-silicate prosperities of the product, it is fully vapour permeable and therefore the paint can be used for difficult applications like old damp buildings or new builds where walls and renders are still wet and use of standard paints would require minimum 30 days of curing.
Superior matt finish hiding substrate imperfections
As matt surfaces are not reflecting light it is much easier to use the product on non perfect walls orceilings.
Drip free
Less wastage and mess - the high viscosity of the paint makes it painter a friendly product and highly suitable for ceilings application.
No mist coat required
Smaller material usage and less time required. The product is partly absorbed by the substrate and then chemical reaction is developed.
Touch dry after 15 minutes
Second coat can be applied almost immediately.


Subscribe to our YouTube channel to view our latest videos

Other Paints