Terrix® Pl-SX-X is ready-to-use plaster coat for machine levelling of interior walls and ceilings.
For final levelling and smoothening of surfaces before painting. Its white colour and smooth surface allow for a reduction in the number of coats necessary to obtain a full decorative effect. When set and hardened, very easy for sanding. Suitable for use on all typical mineral surfaces (such as concrete, cement, limestone, lime and gypsum plasters and plaster boards).
Due to its chemical formulation, the product dries even when higher relative humidity levels occur.
At present, PCC Terrix offers a total of 4 products in the Interior plasters category.
One for manual application and 3 for mechanical application.
PL-SX spray plaster for manual application
PL-SX-S spray plaster for mechanical application - currently, the most frequently purchased Terrix product in Europe
PL-FS-S fast-set spray plaster for mechanical application as well
PL-HB-S high-bond spray plaster for spray application
Benefits to the customer
Click below to expand:
Due to the ease of spray application with the pre mixed plaster, on site labour times are greatly reduced - up to 500m2 / per man per day
The Terrix® spray plaster there is no need to wait for taping and jointing to be fully dry - the product can be applied on the same day.
The product is permanently connected to the substrate.
There is no risk of cracking or flaking.
The product is less sensitive to weather conditions meaning Terrix® spray plaster is ready for painting usually next day, in extreme situations after 3 days. Traditional skim coats and competitor’s spray coats during winter conditions needs up to two weeks to be ready for painting.
Spray plaster is premixed and does not required water or mixing on site. Additionally there is almost no overspray which means very little cleaning after application.
The quality of the finish is much better then standard skim coat plastering or other systems . It is delivering a very smooth, decorative surface quality not achievable with skim coat plastering.
Unlike other spray plasters Terrix® PL-SX-S chemically bonds and penetrates into the plasterboard. Application of Terrix® PL-SX-S won’t have any adverse effect on plasterboard. In some cases, application of Terrix® PL-SX-S can prevent delamination of paper from defective plasterboard.
The chemical formulation of the product and its application prosperities allow for more consistent finish leading to very little snagging.
- Less operatives on site leading to reduced risk of accidents
- Reduced risk of falling from heights - ability to spray up to 3m without scaffolding
- Very clean application process - spray plaster is premixed and does not required water or mixing on site. Additionally there is almost no overspray which means very little cleaning after application
- Reduced dust risk on site. If Terrix® Self-levelling spray plaster is used, no sanding is required
- No mist produced during spraying - safe for application without dusk masks
Benefits to the applicator
Due to the ease of application. Terrix® spray plaster is extremely easy for spraying, wiping and sanding.
Due to the products permeability and partly chemical set capabilities the work process can be accelerated, in return releasing the areas ahead of program for others trades.
For initial 20 days after application the product is very easy for sanding.
Ready for painting usually next day, in extreme situations after 3 days.